Thanks:
0
Likes:
0
Dislikes:
0
-
Konica Minolta C6000 with J-9451 can't duplex
Good afternoon all...
Working on a new customer looking for help on a machine that has had an issue while duplexing. Simplex jobs are not an issue and print with solid image and little to no jams. A duplex job will jam at pre-registration of the 2nd side with an error code of J-9451 which points to PS23. In I/O check mode the sensor works without fail and with a slight touch. We have replaced the sensor and the actuator and the ADU Drive Board with the same issue. I would go for the Main PCB but if the sensor changes states I don't want to just swap components until I know what the failure is. I was thinking there might be an issue with either ADU loop motor (M57) or ADU reverse motor (M32) but can't remember if I checked those in I/O check mode.
One funny thing I noticed is that the J-9451 doesn't show up in the Jam list of the Management List...
Anyone see an issue like this? TIA
-
Re: Konica Minolta C6000 with J-9451 can't duplex
it is all the time or heavy stock only?
-
Re: Konica Minolta C6000 with J-9451 can't duplex
It's all the time with different paper stocks and different sizes.
-
Trusted Tech
50+ Posts
- Rep Power
- 0
Re: Konica Minolta C6000 with J-9451 can't duplex
Hello,
CHECK THE MOTOR who turn paper on duplex A03U M111 00 HB Motor /50, and clean the SHAFT who turn on roller and transport papre for duplex and exit.
That shaft is dirty.
regards
Shaft.pdf
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks