Thanks:
0
Dislikes:
0
-
Technician
- Rep Power
- 30
Konica 601 unable to print from network
I have a Konica 601 that was only showing the hour glass on the the screen. I replaced the OACB with a complete used Board, the copier now works normally but I am unable to print to it. I changed the IP to the correct one and I can ping the address from the computer. The print que after about 5 minutes says the copier is busy. No jobs to print ever show up on the copier screen.
Any suggestions on what could be the issue?
-
Re: Konica 601 unable to print from network
you need to take the print chip off the old pwb.
-
Technician
- Rep Power
- 30
Re: Konica 601 unable to print from network
I did try that, but no difference.
-
Re: Konica 601 unable to print from network
have you reflashed all the firmware?
-
Re: Konica 601 unable to print from network
can you print a cofig page. silly question but did you put the chip in the right slot and turned the right way. the notch can be hard to see
-
Technician
- Rep Power
- 30
Re: Konica 601 unable to print from network
I'm not able to print a config page, yes the chip is lined up notch to notch. I'm not that familiar with Kon/Min equipment, how do you update the firmware?
-
Re: Konica 601 unable to print from network
you do have the IC-208 print controller correct?
-
Technician
- Rep Power
- 30
Re: Konica 601 unable to print from network
20170414_153013_resized.jpg Yes, I believe it is installed correctly.
-
Technician
- Rep Power
- 30
Re: Konica 601 unable to print from network
It came off the old board so it should be an IC 208
-
Re: Konica 601 unable to print from network
no chip above it like in my pic?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks