Working on this a DF-701 feeder that I keep getting a c-6105 code on. I have replaced the CIS sensor(ps7) , CIS motor (M5) and the Control board (DFCB) and still I get the C-6105 code when doing 2 sided only will work just fine 1 sided. Happens with copying, scanning and faxing. Looking for some ideas thanks.
Also have updated the firmware
replace the reader cable for two side
I was working on this yesterday and I replace the ADF Cable that connects to the second side reader (A3CEN11711) and still no luck. weird thing is if I spin the wheel that move the cleaning roller out of home position and then scan in the documents it works no problem then I let it reset its self and run them again and bam c-6105 again
That code points directly at the CIS cleaner sensor, motor or DF control board. Check that the sensor is being block and unblocked in proper timing. Service manual suggest replacing sensor, motor or DF control board. In that orderOriginally Posted by Cookr
I was working on this yesterday and I replace the ADF Cable that connects to the second side reader (A3CEN11711) and still no luck. weird thing is if I spin the wheel that move the cleaning roller out of home position and then scan in the documents it works no problem then I let it reset its self and run them again and bam c-6105 again
Yep unfortunately i have already changed all that. From what i can tell the timing is fine when it does run the cleaning roller spins and stops with every sheet
Jee on every page seems excessive. Have you done an error clear under Initialization?
I am getting more problems that simply seems software related.
Whatever
The only way you can be sure the timing is right is to compare it to a know wiring DF. The are markings that are nearly impossible to read. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
OK I went out to this call yesterday and replace the dual scan board that is in the back of the machine that the cord plugs into and still getting this code and the next step I would think would be the CIS but its very expensive to get not knowing if it is even the problem which i don't think it is anyway. Any more ideas??? thanks
Oh yeah another question is there a way to just disable the second side scanning and make it work just like a RADF so it just pulls the paper back in?
Did you happen to mention what MFP this DF is on? My psychic powers are just not that great in the afternoon.
You could go to service mode > System1 > Problem Unit Isolation Set > DF > UnSet ... or you could just power down the MFP, unplug the DF, then power back up. Same effect in the end. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Posting Permissions
Thanks: 
Likes: 
Dislikes: 
Reply With Quote
Bookmarks