I have installation procedure for hard. I installed mechanical and electric all components , its is OK, but i don't have procedures for initialization, for registered in service menu and administration settings. I install optin DF-629, but until I declare it in service menu it does not work, after it it work perfect. I think I need to made other few settings or initialization procedures to disappear that cyan and magenta lines.
You need to complete the basic setup.
For the Cyan/Magenta lines to disappear, you need to enter the following in service mode:
(Bare in mind, in recent firmware versions, you can access a setup wizard by entering service mode and pressing STOP, 3. This brings you to the following necessary steps, although they can be done separately.)
- Date/Time - This can be done by entering service mode and pressing STOP, 1, 1, 4, 4, C.
- Serial Number Input - ADF Serial Number and any other options if you'd like.
- Unit Change - For confirmation that this setting has been checked, you need to simply switch one from User to Service and back again.
- List Output - Print at least the 3 options on the left hand menu.
Really do you need to print a list?
Whatever
It hasn't said to print lists in the set up for a while.....but it does say to carry out "non image area erase"
Tip for the day; Treat every problem as your dog would.....If you cant eat it or f*ck it....then p*ss on it & walk away...
Bookmarks