BizHub C454 finisher removal

[Staggan]

Hello

I have removed the finisher and bridge unit from a C454 and replaced the cover for paper exit.. but there is also a sing arm / guide that also needs to be put back...

I cannot find any pictures in the manual regarding how this triangular guide fits....

Can anyone help?

Thanks

[emujo2]

post a pic of the piece. Also, there is an exit sensor that needs to be removed. This sits on top of the fuser exit area. Emujo

[Staggan]

Hello

This is an image of the guide / arm...

KonicaGuide.jpg

Thanks

[emujo2]

Pain the ass to put back in..Finisher.jpg

[Staggan]

I can kinda see where it goes, but can't see what happens to the other parts that are there...

I can't find anything in the parts manual.. and waiting for a copy of the service manual at the moment....
I think I know the sensor you are referring to, but there are two swinging arms that are, I think, above where that guide goes... not sure what happens to those...

Thanks

[allan]

Jip.

[emujo2]

That sensor needs to come out, it's only used when a bridge or job separator is installed. Just remove the small cover and you'll see the connection and screw. The sensor assembly sits on top of the fuser exit section. Emujo