Thanks:
0
Likes:
0
Dislikes:
0
-
Trusted Tech
50+ Posts
- Rep Power
- 15
BizHub C454 finisher removal
Hello
I have removed the finisher and bridge unit from a C454 and replaced the cover for paper exit.. but there is also a sing arm / guide that also needs to be put back...
I cannot find any pictures in the manual regarding how this triangular guide fits....
Can anyone help?
Thanks
-
Re: BizHub C454 finisher removal
post a pic of the piece. Also, there is an exit sensor that needs to be removed. This sits on top of the fuser exit area. Emujo
-
Trusted Tech
50+ Posts
- Rep Power
- 15
Re: BizHub C454 finisher removal
Hello
This is an image of the guide / arm...
KonicaGuide.jpg
Thanks
-
Re: BizHub C454 finisher removal
Pain the ass to put back in..Finisher.jpg
-
Trusted Tech
50+ Posts
- Rep Power
- 15
Re: BizHub C454 finisher removal
I can kinda see where it goes, but can't see what happens to the other parts that are there...
I can't find anything in the parts manual.. and waiting for a copy of the service manual at the moment....
I think I know the sensor you are referring to, but there are two swinging arms that are, I think, above where that guide goes... not sure what happens to those...
Thanks
-
Re: BizHub C454 finisher removal
-
Re: BizHub C454 finisher removal
That sensor needs to come out, it's only used when a bridge or job separator is installed. Just remove the small cover and you'll see the connection and screw. The sensor assembly sits on top of the fuser exit section. Emujo
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks