Machine cannot get through an adjustment without coding out. Replaced black developing unit and developer. Removed, cleaned and inspected image correction unit. Swapped drums and charges with another color.
SERVICE MANUAL:
The output voltage of the
IDC sensor (IDCS) is
detected more than the
specified value on the
patch/K of the MPC
maximum output.
•
• Printer control board
(PRCB)
• Developing unit/K
• IDC sensor (IDCS)
• Color registration shutter
solenoid (SD4)
******With that being said I called Konica tech support and they pointed me to a knowledge base solution from the c8000 that does not really follow what the manual told me. I have a plan of attack here but was just wondering if anyone has seen this that could make my plan easier.
Knowledgebase solution:
Error
C-2821 (Y), C-2822 (M), C-2823 (C) or C-2824 (K)
Root Cause
Charging potential Vh terminated abnormally.
Workaround/Fix
To troubleshoot:
1. Check the connection of the process carriage drawer connectors.
2. Access I/O check mode 51-xx. It should be ON. If not, replace the subject part.
- xx=00 (Eraser lamp/Y - EL Y)
- xx=01 (Eraser lamp/M - EL M)
- xx=02 (Eraser lamp/C - EL C)
- xx=03 (Eraser lamp/K - EL K)
3. Check the connection of CN160/CN161/CN162 (Printer Control board) and wiring for the connectors. If any problem is found, correct it.
4. Check if ICP16 on the Printer Control board (p/n A1RF H050 0D) is OPEN. If so, replace the problem board.
5. If the cause could not be specified by the above steps, replace the parts in the following order.
- Printer control board
- Drum potential sensor/Y/M/C/K (p/n A1RF R747 00)
- Eraser lamp/Y/M/C/K (p/n 65AA 8307 0)
- Wiring (p/n A1RF N123 03 - Main Body Wiring /3, p/n A1RF N147 00 - Transfer Wiring /1 and p/n A1RF N151 00 - Toner Detection harness /1)
Bookmarks