Hi
we have a c258 with an internal stapler brand new that when you print banners 1200 x 297 is smudging the last third of the sheet
Does anyone know the solution to this
Firmware is latest
Hi
we have a c258 with an internal stapler brand new that when you print banners 1200 x 297 is smudging the last third of the sheet
Does anyone know the solution to this
Firmware is latest
Is the thickness set correctly?
Thick 1 and up print slower so less chance of smearing.
How heavy is the media? =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Try playing with the fuser loop. Or slow it down as mentioned in previous post.
We had different issue however, so in case you or someone is experiencing halftones being not filled properly a.e. peeling off (white spots) then try to increase the temp by 10'C to start with until you get good result. The fuser can't keep up. It usually happens on the last 1/3 of banner and 1/4 from edges. So smudging or peeling is visible, but not always.
Firmwares HERE.OK Google! ... will I need Berrocca this morning?
Bookmarks