Hi, My printer show error code 2558 , after developer replacement. (chip reset ).
but when i power on again. show error 2558. and TCR level show 12% ~ 19% for black.
- Trouble reset and Power up printer, NO ERROR DISPLAY ! BUT PRINTING DIRTY....
Hi, My printer show error code 2558 , after developer replacement. (chip reset ).
but when i power on again. show error 2558. and TCR level show 12% ~ 19% for black.
- Trouble reset and Power up printer, NO ERROR DISPLAY ! BUT PRINTING DIRTY....
If you only reset the chip without replacing the developer then that will be your problem. Replace whole developer unit. It is possible there is a toner supply issue but i would replace dev unit 1 st.
Relaxing, no big issues, this because your developer has no toner. So just take a few amount of toner and put in your developer unit, and wait machine to run, then try printing, if not yet put in other toner then run the machine. Good luck
Reset the code and try to print if toner is high remove the cartridge toner, and keep empty Cartredge with active chip.
High TCR means too much toner in develop unit. Do yourself a favour and try to do 30 sky shots without any toner bottle installed. Or if that is not possible, then try it from service in test mode > halftone > set density to 255 and print 30 x A3 Black (1PC)
If there is no toner in developer and shows 19% , then just put new dev unit in as your old TCR sensor may be damaged.
Firmwares HERE.OK Google! ... will I need Berrocca this morning?
This caused by developer charge and some time more toner
Bookmarks