Thanks: 
Likes: 
Dislikes: BH-C-280, new TB ruined after 1K.
Anyone seen this before?
Hans
BH-C-280, new TB ruined after 1K.
Anyone seen this before?
Hans
" Sent from my Intel 80286 using MS-DOS 2.0 "
Only one think .... closed door too hard
Yes indeed I have. the issue is due to those stupid claws that lightly run on the belt itself. I have had a few break on me with the 220/280 series and luckily they were replaced through garantee. In the earlier belts there was just one of those claws and when the paper hit just right it would push it over Centre and poke a hole in the belt. Results were always known to me as the Butterfly Problem. The hole would produce Butterfly figures on prints. Heck of a Thing to deal with when you don't have alot of belts in inventory. My advice, do as I do and rip those stupid claws off and be done with it. I have ripped off all of mine since about 5 years and i think had one small issue that 1 Piece of paper slipped through above the belt and rested on top. made a mess, but the belt was fine. Best of luck!
Mitch
separation claws, remove them
529958737.jpg
Hmmm. Looks familiar. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Was that picture just a way for you give us all the finger? LolOriginally Posted by blackcat4866
That picture was sent to me 5 days ago. I responded with "Hey! Which finger is that?"
His response: "Pointer. lol."
=^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
That's weird. Automatically my post appears twice.
BH-C-280, new TB ruined after 1K.
BH-C-280, new TB ruined after 1K.
I SWEAR I posted it only once but only edited it.
Hans
" Sent from my Intel 80286 using MS-DOS 2.0 "
The separation claw can be removed but I would make sure that they are not damaged and if they are then replace them
I was wondering what happened to my post here but it's in the twin thread. Forum Gremlins, apparently.
Started in the copier service business in the fall of 1988 and worked at the same company for 33.5 years, becoming the senior tech in 2004 but left to pursue another career on 4/29/22.
Reply With Quote
Bookmarks