I have this FS-534 finisher attached to a C754e. It appears that the alignment arms are worn and need to be replaced. I looked all over the service manual and for the life of me can’t find a procedure for replacing these arms. I have the mainframe manual and went looking for a finisher service manual on the Konica site under one stop service but crapped out. Does such a procedure exist? I ant to strangle the asshole who designed this finisher.
Heres a vid of how my prints are exiting
Look for Konica Minolta field Bulletin..looks like paper cuts armsOriginally Posted by Qball
Sent from my SM-N920V using Tapatalk
FS-534 alignment plate wearing.
How about this?: =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
The second time I had this problem on the same machine I decided instead of replacing the alignment plates again I would adjust the mechanical centering on all trays to the rear a few millimeters then use centering in service mode to realign image on paper. This way the paper doesn't line up on the edge of the plate. That was 2 years ago and I have had no more problems with that since.
Dude, that’s killer. Thank you!
Thanks: 
Likes: 
Dislikes: 
Reply With Quote
Bookmarks