Jam code J 7217 ..finisher FS 533...paper leaves fuser half way into finisher jams!Copier runs all trays with out finisher attached....installed another FS533 finisher same jam code same thing.????
Sent from my SM-N920V using Tapatalk
Jam code J 7217 ..finisher FS 533...paper leaves fuser half way into finisher jams!Copier runs all trays with out finisher attached....installed another FS533 finisher same jam code same thing.????
Sent from my SM-N920V using Tapatalk
I had one doing something similar a little while ago. In the end it turned out the main body exit was binding causing a timing error when a finisher was fitted. I stripped & lubed the exit bushes and it's been ok since. Might be worth a try since you've already eliminated the finisher itself.
Tip for the day; Treat every problem as your dog would.....If you cant eat it or f*ck it....then p*ss on it & walk away...
Did you ever resolve this Antone?
I would be interested to know what you found.
Thanks..
Just following up on this. I followed a tech in on this exact problem today. He had also run the finisher on a different machine with no fault but couldn't make it work on site.
I stripped & lubed the main body exit and then ran 500+ prints with no further issues. It confirms my theory that its a timing error between the main body exit & the finisher unit.
Hope this info is useful to someone in the future.
Regards....
What jam codes? I have a FS-533 in my trunk that was making 72-17 jams today. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
J7217 and sometimes j7219. I've only had it happen when fitted to a C454e. I'm guessing the extra speed causes the timing issue.
Regards...
Bookmarks