Originally Posted by
copyman
So can you swap 4 series developer units from one machine to another without trouble ???? I didn't see anything about it in the serv manual. There are a few bulletins on the K/M knowledge base about developer issues. So looking into these as well.
I will investigate further tomorrow with drum rotation times etc when there
Now that I think of it something was strange, when I was swapping K dev unit I noticed the wire for K connector was out of the clasp. My first thought was some unscrupulous dealer had swapped a bad dev unit before returning to leasing company.
Should I be able to salvage the dev unit I put in today? It came out of a machine with only 20k on it. Customer said they were only able to run a few pages after I left. It would reset but throw the code after one page was printed. So they just turned it off. Hopefully I can still use it since it wasn't used much. hate to waste a good unit.
Thanks again for the replies.
Bookmarks