@ Synthohol,
I thougt, a ICP is the same as a normal fuse? e.g. 50V/2A
Could I bridge ICP3 with a small wire to test if the error C-2152 disappeares and than solder a correct ICP with the correct values?
@ Synthohol,
I thougt, a ICP is the same as a normal fuse? e.g. 50V/2A
Could I bridge ICP3 with a small wire to test if the error C-2152 disappeares and than solder a correct ICP with the correct values?
here a picuture from ICP3
I removed the board and for a test I bridged ICP3 with a wire. After replacement the code 2152 has disappeared and the machine works fine
Now, I removed the wire bridge and thougt, the code would have to displayed again. Surprisingly, that was not the case
The machine works normaly, without any error code.
I can only imaging, that a connector on the board had a contact resistance and this was eliminated by removing and replacement the board.
Or is there any other explanation for that?
Could you have accidentally bridged the ICP with solder while soldering? Those components are so small that a bead of solder can easily bridge the contacts. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
That's a good Idea!
I used a special smd-soldering iron with a very thin tip and used strong magnifying glasses.
I will again check the solder point closely.
Yesterday I checked the ICP for a solder-bridge. There was absolutely nothing to see.
So, the only cause left, is the possibility that a connector had a contact resistance.
Bookmarks