Thanks: 
Likes: 
Dislikes: alternatively getting Miss feed detected message while scanning from ADF (Konica Minolta C360)
I didn't find out any miss feed, after restarting machine, it will work for while & again getting the same message
I have attached herewith screenshot
alternatively getting Miss feed detected message while scanning from ADF (Konica Minolta C360)
I didn't find out any miss feed, after restarting machine, it will work for while & again getting the same message
I have attached herewith screenshot
Sounds like one of the sensors is either dirty or lever getting hung up. Did you open the spring loaded door on left underside of ADF and blow paper dust off black felt pad & sensor? When this felt pad has paper dust on it I have seen it cause intermittent jams and other strange things.
jam code? =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
I’m assuming you have replaced all the DF rollers?
Where does the original stop? Is it catching? Check all the mylar guides, especially the small square ones they get small tears the paper will catch.
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Not showing any error codeOriginally Posted by blackcat4866
It showing message as I attached above
"misfeed detcted
Remove paper indicated by 0"
Oh, maybe you could print a Management List? Around page 13 you'll find a long list of every jam that ever happened.
The enduser screen is not of much use unless you turn on DIPSW 30-1 so the machine displays the actual jam code. It's call Collection Data mode.
=^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Blackcat,
Thank you for your last post. I will cut and paste this one in my tech file.
DR
Issue has been resolved
I just reinstalled the Feeder roller and cleaned the ADF by using blower
Now its working fine..
And still not jam code? This is no use to anybody.
Use the resources that are available to you. We all use jam code numbers to identify specific jams. You don't know if you were even in the right part of the machine. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Reply With Quote
Bookmarks