Biz hub 3850f

[antone]

Error E301....did power reset...reset memory....anything 2 add?

Sent from my SM-N920V using Tapatalk

[Synthohol]

from the service manual, does not even list relevant parts to replace!! Trouble type
Trouble code	E301: Referring incorrect memory E302: Incorrect command E303: Finished due to error inside Qt library E304: Finished due to error outside Qt library E305: Program forced to stop
Rank	C
Detection timing	Received an error of irregularity.
Trouble isolation	-
Relevant electrical parts	-

(2) Procedure

1	Turn OFF the main power switch, disconnect and then connect the power cord. Wait for 10 sec. or more after connect the power cord, and turn ON the main power switch.	-	-
2	If the above actions do not solve the problem, contact KM.

[antone]

from the service manual, does not even list relevant parts to replace!! Trouble type
Trouble code	E301: Referring incorrect memory E302: Incorrect command E303: Finished due to error inside Qt library E304: Finished due to error outside Qt library E305: Program forced to stop
Rank	C
Detection timing	Received an error of irregularity.
Trouble isolation	-
Relevant electrical parts	-

(2) Procedure

1	Turn OFF the main power switch, disconnect and then connect the power cord. Wait for 10 sec. or more after connect the power cord, and turn ON the main power switch.	-	-
2	If the above actions do not solve the problem, contact KM.

Special firmware update...took care of trouble code

Sent from my SM-N920V using Tapatalk