Imgur: The magic of the Internet problem is this i removed the trans belt after the print. even when i open the door during the print i get that pattern.machine got like 1mil ticks. i already changed transfer belt and transfer roller. same thing. any clues?
Does it happen if you print B&W only, like the internal config test page?
Looks like you need to replace the magenta imaging unit
it happens in every page. even if its halftone, all colors and even on counter list print. this is just a demo. i swapped the iu's too. nothing.
Seems like Magenta Developer problem .
Try to replace it .
I'm going to make an educated guess that you've lost magenta primary charge. With no magenta primary charge the drum is entirely imaged magenta with no voids.
The reason copyman asked if it happens on B&W is that the color section of the HVT are disabled during monochrome copies, so black copies should look normal. So what is the answer? Black only copies, what happens? =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
You have covered the IUs, then HVT should be the culprit. Had it once on C258 with yellow, with the difference it blanketed the whole ITB not just part of it.
Just one thing puzzles me, isn't the meter count printout done with just one PC (K)?
Does the belt retract when you manually rotate the gear? Anything snapped on M 1st transfer roller? Pressing against the M drum one side only even during K only print?
Sent from my Mi A1 using Tapatalk
Firmwares HERE.OK Google! ... will I need Berrocca this morning?
hello. the problem is not in magenta. is on anything i print. in the pic is just a halftone i printed to test. it does that on all prints b/w colored halftone copy print etc.
What does the belt look like when you take it out?Originally Posted by lazymangr
Sent from portable device using fast cheapset!
Firmwares HERE.OK Google! ... will I need Berrocca this morning?
i have replaced belt with new and still got the same. all the info guys is on the top post
i want to add 1 thing. the problem occurs only on duplex and only on the front side.
I am assuming that if you stop the toner image on the belt before transfer to the page it is a complete image ?
If so the problem lies with the transfer roller and we have had this before, check the springs and the lift cams
Thanks: 
Likes: 
Dislikes: 
Reply With Quote
Bookmarks