Have a Konica 222 that I had to replace the solenoid to the toner unit. To do that everything out of the back and front have to come out. replaced it put it all back together and it took care of that problem and now the document feeder won't work it's not even recognizing it has one on it. I trace the wiring in there were two connectors with gray wires that went to the main board and another red and green wire that went down to a board below they were all plugged in the only thing I could see and I'm not sure of it because I didn't have my glasses and it's such a small area is there was a blue wiring harness that comes from above from the board on the top left that you can pull out that has the fax connector on it it comes out of their down to the mainboard where you plug it in the mainboard there might be a pin bent over I couldn't really tell. Does anyone know if that blue wire coming down from that board even has anything to do with the doc feeder. I don't believe it does. It looks like I've reconnected everything right I've done it over and over and yet I still not getting any power to my doc feeder. Any ideas of what I could have forgot to do or could it be a bent pin on that blue wiring harness
Bookmarks