C451 IUs Reset Problem

[mdtrinh]

I am facing a strange problem as never happen to me before.
- Copier shown with IUs (yellow, magenta, cyan) need to replace pop up message.
- Make a color test pages, they look sharp & clean.
- Replace reset chips to each IU to reset pop up message.
- It shows C255B (IU yellow TCR adjustment error), clean sensor -> no good, install old chip back.
- C255B error gone, but C255A error show up, install old magenta chip back.
- C255A error gone, but C2559 error show up, install old cyan chip back.
- Now, everything function normal, all TCR levels around ~ 7.0.
I am back to square one with the pop up message.
Please help

[Synthohol]

turn off consumable life reminders.
or god forbid replace them with new ones not just the friggin meter chip!!!

[mdtrinh]

turn off consumable life reminders.
or god forbid replace them with new ones not just the friggin meter chip!!!

Already tried setting according to tech bulletin # 8607, only this copier still shown, others 5 machine were off in life reminder.
Copies still look good & clean, why waste good ius, try to be environmental friendly.

[copyman]

Possible chips labeled wrong, and not for that model? Anytime chips are replaced, especially on these older models anything can happen but for all 3 chips to code out is very strange and makes me think they are wrong chips. Did the quality look good before chipping?

I would try chips from different supplier. Worth a shot, a lot cheaper then new IU's !!!

[mdtrinh]

Possible chips labeled wrong, and not for that model? Anytime chips are replaced, especially on these older models anything can happen but for all 3 chips to code out is very strange and makes me think they are wrong chips. Did the quality look good before chipping?

I would try chips from different supplier. Worth a shot, a lot cheaper then new IU's !!!

Yes, it looks sharp & clean before chip, re-install old chips for now to avoid machine down until it can be resolved.
At this point, everything work but annoying pop up message.

[Synthohol]

is the firmware the latest? or the same as the successfully message free ones?

[mdtrinh]

is the firmware the latest? or the same as the successfully message free ones?

Yes, it is same firmware with the rest of other machine and I cannot figure it out why it is after checking firmware, setting.

[Synthohol]

print the list output for both machines and compare the bit switch pages.

[Blizzoo]

I know that if you put new chips on used IU's the machine will consider the IU's are new and adjust the TCR lever wich fails due to the fact that the units are already used.

[copier tech]

No need to waste money on these chips, update the life stop fw & turn off the “replace image unit mesage” as said before repacing the chips the machine will calibrate new IU values yet the drum is old/worn!