Thanks:
0
Dislikes:
0
-
Senior Tech
100+ Posts
- Rep Power
- 0
C6500 C-2811 developer spiled
Hi,
I have replaced Y developer and made the necesary adjustment's about 30 days ago (it has 5%). Now it had C2811 so when I open it it has Y developer spilled mostly in the front part. I know that it cand dump developer thru lower-front part of the station, because it has the metal plate that under a lot of pressure releases what is inside. But how can I find why is doing it?
-
Re: C6500 C-2811 developer spiled
What is the life status of drums?
Replace developer without replace drum and charge unit is never good.
-
Senior Tech
100+ Posts
- Rep Power
- 0
Re: C6500 C-2811 developer spiled
Drum is altmost at the end of life and charge is replaced preriodicaly because it is the only one that gets regulary dirty.
Drums that I use ar DU-104 and usualy they are doing 200%.
But if the prolem is the drum why is spiling, mostly, in the front and not on the all the unit?
-
Re: C6500 C-2811 developer spiled
I also use du-104 and can confirm what you said but you never know...
Check this piece under the magnetic roller if it is bent or too close to roller and brush toner from roller,it could cause toner spiling and drum potential sensor get dirt and error code like you have.
-
Senior Tech
100+ Posts
- Rep Power
- 0
Re: C6500 C-2811 developer spiled
As I sayid developer is spilling in the front part as it shows in the photoWhatsApp Image 2018-05-30 at 15.53.26.jpg
-
Re: C6500 C-2811 developer spiled
I dont think that is Y developer all over the place,its more likely Y toner spill from toner supply section.
Check toner supply section and sponge seal if it is damaged .
-
Senior Tech
100+ Posts
- Rep Power
- 0
Re: C6500 C-2811 developer spiled
I apriciate the reply but it is developer, stick's to the magnetic screwdriver.
-
Re: C6500 C-2811 developer spiled
Ok i beleive you,just trying to help but i never seen developer could spill so far and all over the place from developing roller...
-
Senior Tech
100+ Posts
- Rep Power
- 0
Re: C6500 C-2811 developer spiled
I have replaced: developing unit + developer + drum + corona, all at once and all new
I have done the adjustment's and so far is ok
I will come back if is droping again
-
Re: C6500 C-2811 developer spiled
Since you replaced the dev unit, I will say your problem will be solved. Had a few of these in the field. The dev unit would spill after they reached a certain age.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks