This occurred after doing an all clear .
Not sure what got disabled . The button just beeps . The fax board is "set" .
Greatly appreciate the assistance
This occurred after doing an all clear .
Not sure what got disabled . The button just beeps . The fax board is "set" .
Greatly appreciate the assistance
System setting forward to page 2 register key setting hard key Key 1= Fax_Scan.......check these settings ok
Sent from my SM-N950U using Tapatalk
Power down for 15 seconds...ok
Sent from my SM-N950U using Tapatalk
Chech to see if hhd is set
I'm with the above. It needs to know that it has a Hard Drive to allow these functions and full reset usually sets this to off
Thank You very much that was it.
One other question . The unit had the old vendors logo pop up . I deleted that info but now I am getting a message on the unit that says " no animation guide available. Thankfully It does not effect any functionality. How do I get rid of that message ? I can not find where in the unit I deleted the panel file
I believe you can just get the missing firmware. Don't have to install it all. Usually you can only get it from a dealer.
Bookmarks