While the machine is pushing a set of papers to the exit tray, the next one is coming in. Sometimes, it doesn't stack correctly or causes a jam. Anyone see this before?
While the machine is pushing a set of papers to the exit tray, the next one is coming in. Sometimes, it doesn't stack correctly or causes a jam. Anyone see this before?
Most likely damp paper causing this issue especially if the prints come out a bit curly.
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
have one doing the same thing here. suspect the dup unit isnt moving the first sheet of the set fast enough to clear in time.have had it crumple paper under the fuser a few times.
Now this machine won't even run 1 sheet. It jams right at the exit. Any ideas on this?
try stapling. if it works then i would be looking at things that could slow down paper travel, eg motors clutches gummed up bushings.
Nope. Still jams at exit
Turns out it was a couple of problems
Exit actuator was broke.
Rails in finisher were bone dry causing the guides to struggle to move.
Only 21k on this machine.
Yep. Lubing the rails is the fix. Just had another one start that. Lubed the rails and started working again. Going to be part of the regular maintenance on this machine
Bookmarks