Konica Minolta C253 Prints B&W

[mearmi]

Having seen your example I would say the transfer belt is the culprit. Try a new transfer belt. and roller.

Replaced the transfer belt and Roller. Worked one day and got same problem again.

Please advise.

Thanks

[Synthohol]

check all the HV terminals and springs for damage or even corrosion yet?

[mearmi]

If the primary transfer clutch was the culprit, there should be a C2152 code since PS31 wouldn't be able to detect retraction. We had this happen on more than one occasion way back when and there was a bulletin that came out with a change to the pawl on the belt and a lever on the machine causing the issue.

Thanks for your reply. Replaced the belt, machine worked for one day but same problem again. Which lever on the machine was causing this problem?

Please advise.

Regards,

[srvctec]

Thanks for your reply. Replaced the belt, machine worked for one day but same problem again. Which lever on the machine was causing this problem?

Please advise.

Regards,

Are you not getting a C2152 code? I'm shocked you're not getting that code with the symptoms you have.

It's actually a bracket, not a lever like I mentioned before. But all of what I suggested is only for the code C2152. If you aren't getting that code, there must be something else going on since the sensor involved would detect every single time when the primary transfer rollers move. I really don't know what else to suggest at this point.

[mearmi]

Are you not getting a C2152 code? I'm shocked you're not getting that code with the symptoms you have.

It's actually a bracket, not a lever like I mentioned before. But all of what I suggested is only for the code C2152. If you aren't getting that code, there must be something else going on since the sensor involved would detect every single time when the primary transfer rollers move. I really don't know what else to suggest at this point.

No i m not getting any code

Thanks

[mearmi]

No i m not getting any code

Thanks

Please advise

thanks

[srvctec]

I really don't know what else to suggest at this point.

See above.