Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13
  1. #11
    Junior Member dherhut's Avatar
    Join Date
    Oct 2018
    Location
    santiago
    Posts
    5
    Rep Power
    0

    Lightbulb Re: Konica Minolta C284e Firmware

    Dear, it is true what you tell me but the konica technician in a previous review detected the following: "This error code is associated with DSCB-1 card, which controls the scanner and ADF of the equipment, which in the In addition, the machine has another error code that is C-D262, which refers to a wi-fi card model UK-208, which as in the previous case, this machine does not have .
    It should be noted therefore that having made the corresponding field tests, such as reset error codes and physical verification of components, it can be concluded that the main card is with logical damage, which caused the team to behave erratically and without being able to perform any function.
    In conclusion, the damages described above are apparently attributable to sudden drops and increases in voltages in the electrical network where the equipment is connected. "
    Logically, the repair offered by the service was extremely expensive (USD $ 6,000) only for the change of the plate, which I found on eBay at less than $ 500 USD, but I could not install it on firmware ... I'll keep trying, if I have any other suggestion I would appreciate it
    regard

  2. #12
    Junior Member dherhut's Avatar
    Join Date
    Oct 2018
    Location
    santiago
    Posts
    5
    Rep Power
    0

    Re: Konica Minolta C284e Firmware

    Is there someone who can help me ???

  3. #13
    Junior Member dherhut's Avatar
    Join Date
    Oct 2018
    Location
    santiago
    Posts
    5
    Rep Power
    0

    Re: Konica Minolta C284e Firmware

    Quote Originally Posted by Synthohol View Post
    ok first off, the 6901 code is for the dual scan board you mount to the mfp board.
    is it good?
    put the old mfp back and leave the dual scan board off and unplug the doc feeder other wires.
    if no codes and you can make copies there is your issue i think.

    the code is for
    DSC board mount failure 1
    Trouble code C6901
    Rank C
    Detection timing When MFP detects that DSC board/1 (front side) is not properly installed.
    did you swap to a single sided feeder?
    is the right feeder selected in service mode?
    details please why change the MFP board for the DSC issue? especially if the code comes right back with the new MFP?

    also M1 is the firmware you want, J9 is hella old.
    dear .. I've really kept trying, I did what you recommended and nothing ... I reinstalled the new board and I still do not solve the problem .... you who are expert in these issues that another option I have ??? I'd appreciate your help.

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •