Konica Minolta C284e Firmware

[mearmi]

Hi everyone

looking for Konica Minolta c284e Firware G20-J6.

Please advise if someone can send me. Will b a great help.

Thanks a lot

mearmi@hotmail.com

[Zesti]

What problem you are facing? pl. describe.

[mearmi]

What problem you are facing? pl. describe.

Thanks for your replying. Client needs to get AirPrint

[Synthohol]

the latest M1 FW supports airprint.

[tech51]

Don’t forget to update the function version or it still won’t airprint.😀

[Synthohol]

Don’t forget to update the function version or it still won’t airprint.😀

Good reminder I forget most people don't read the read me file

[mearmi]

the latest M1 FW supports airprint.

Can u please send me

Thanks

mearmi@hotmail.com

[dherhut]

What problem you are facing? pl. describe.

Hello, I recently had to change the MFPB for a Konica Minolta Bizhub c284e, but I need the firmware (G20-J9) I could not get it and the machine still does not work.
Could you help me with this? If it is necessary to cancel by the firmware, indicate me the value and as payment.
Thank you
dherhut@yahoo.es

[dherhut]

I have tried to install the firmware according to the instructions of the technical manual of the machine, but it has not been possible for me. I do not read the pendrive, I have tried several and the closest to the firmware update is that the format is not correct .... Change the MFP, because it threw the error c 6901. with the new MFP throws the same error. I have tried everything and I can not get the machine to work. Any suggestions?
Thank you

[Synthohol]

ok first off, the 6901 code is for the dual scan board you mount to the mfp board.
is it good?
put the old mfp back and leave the dual scan board off and unplug the doc feeder other wires.
if no codes and you can make copies there is your issue i think.

the code is for

	DSC board mount failure 1
Trouble code	C6901
Rank	C
Detection timing	When MFP detects that DSC board/1 (front side) is not properly installed.

did you swap to a single sided feeder?
is the right feeder selected in service mode?
details please why change the MFP board for the DSC issue? especially if the code comes right back with the new MFP?

also M1 is the firmware you want, J9 is hella old.