Paper jam at exit section ,test all tray papar passage aslso jam,check sensor
Paper jam at exit section ,test all tray papar passage aslso jam,check sensor
just had this same problem on a 958. The loop sensor now sits at the top of the registration unit. the spring on the actuator can come out of place and not enough pressure will be applied to the actuator.
Yep, those spring actuators have done that before.
I hope you can use the following technical bulletin of the Bizhub C458Screenshot_20190110-175722_Adobe Acrobat.jpg
Enviado desde mi SM-J701M mediante Tapatalk
i have the same problem (C759). loop sensor is OK.
how did you fix the problem?
That should be jam on entrance of duplex section.
Duplex drive belt slips because there is no limiter on side of the gear.
I used to put a rubber cover which are used to cover holes for scanner transport screws (4&8 series).
Drill a small hole in it (it should be tight) and mount it on a shaft to make a limiter. Belt will never slip again.
I will post a picture if I still have it.
C759 duplex drive belt.jpg
Edit: Picture posted
White rubber marked with red arrow inserted to prevent belt from slipping.
Last edited by REGSIS; 12-23-2021 at 09:59 PM.
I had the same problem on 2 machines and by removing key item 31 A795897500 Neutralizing Brush from parts manual. the issue got resolved.Jam 3205.jpg
Bookmarks