Hello. I ordered refurbished mfpb for c258. After replace board swapped eeprom1/2, emmc, enter correct machine type, used reset tool, update firmware/boot, machine dropping c163/c164, any sugestions ?
Hello. I ordered refurbished mfpb for c258. After replace board swapped eeprom1/2, emmc, enter correct machine type, used reset tool, update firmware/boot, machine dropping c163/c164, any sugestions ?
If the codes are CC163/CC164 , the manual says wrong model of FW, the machine type information registered to the machine differs from the actual machine type
Tip for the day; Treat every problem as your dog would.....If you cant eat it or f*ck it....then p*ss on it & walk away...
Error Codes > Konica-Minolta > bizhub 130f > page 1 C368&code=CC163
Error Codes > Konica-Minolta > bizhub 130f > page 1 C368&code=CC164
Apparently something is not quite right!!!
Sent from my SM-N950U1 using Tapatalk
REACH FOR THE STARS!!!
Konica Minolta Planetariums!
https://www.konicaminolta.com/planet...gma/index.html
I send back mfpb. Data on MFPB can be corruped. I must wait to resend new. Thanks
I am also stuck with the same issue, I have replaced mfp board, emmc & EEPROM but the issue still persist's. The only thing I haven't try was the reset tool, do you mind sharing it with me please.
1. This error may occur after flashing the MFP firmware. It signifies a ROM contents faulty error due to incorrect or corrupted firmware being installed.
Reinstall the firmware verifying that the firmware file and checksum corresponds to the correct machine. The latest version firmware or system software is available via the Konica Minolta Download Selector.
This error may occur intermittently after replacing PWB-MFP. It is possible the ribbon cable on PWB-MFP was not fully seated.
Remove and reseat the ribbon cable on PWB-MFP.
double check the machine type based on the serial# not the model.
bit sw 25 settings based on serial.
We know a thing or two because we've seen a thing or two.
Also don't ask me for files without a contributor badge.
In this photo, it refers to the code CC-163 and CC-164
Enviado desde mi SM-J701M mediante Tapatalk
i can't find gg9 firmware anywhere. also on my infohub. can you?
Version GG9-84 under special FW
bizhub C258, C308, C368 Special Firmware Version GG9-84 Boot ROM Version G00-02 and Screen calibration
We know a thing or two because we've seen a thing or two.
Also don't ask me for files without a contributor badge.
Bookmarks