C227 / C287 jamming on colour (J30-03)

[byronf]

Hi All,

I have a few of these on the field, we have been replacing fusing units prematurely due to the separation claws breaking. What I notice on these machines is that the client say the jam a lot when they print in color. So I have monitored a few of them and found J30-03 occurs frequently on the machine that break claw. It is obvious that the colour print stick to the fusing roller.

I have bumped the temperature up but have had no luck I even updated the firmware to G00-W2 with no luck.

If anybody has had this issue please enlighten me or if there is a part number for the claws.

Any advice will be appreciated. Thank you[/B][/B]

[Brett GS]

Had this on a few.
Give you a call tomorow.

[Toxic]

On what media and format this occurs?
I do not know if I'm doing wrong all the time but I think the fuser temperature should be lowered rather than increase to help paper not sticking in fuser...

[blackcat4866]

On heavy fill images it helps to increase the leading edge void to 4.0mm - 5.0mm. If you duplex, the same applies to the trail edge void. =^..^=

[allan]

Had this on a few.
Give you a call tomorow.

Fix for the issue?

[byronf]

On what media and format this occurs?
I do not know if I'm doing wrong all the time but I think the fuser temperature should be lowered rather than increase to help paper not sticking in fuser...

This is on normal 80gsm bond. Tried losing the fuser temp as well and the issue still persist.

[byronf]

On heavy fill images it helps to increase the leading edge void to 4.0mm - 5.0mm. If you duplex, the same applies to the trail edge void. =^..^=

Hi I will try this, however it my cause an issue on the field where end users my log calls for image not centralized.

[Bix]

What is the page counter?

[byronf]

What is the page counter?

13355 clicks
But bare in mind that this issue is an intermittent problem across all my machine's

[allan]

Then its damp paper?