Hi.
How to reset Fuser Unit and Transfer Belt life in Konica Minolta c654 ?
Thanks a lot.
Hi.
How to reset Fuser Unit and Transfer Belt life in Konica Minolta c654 ?
Thanks a lot.
They are reset in the service mode AFTER REPLACING units. Call a qualified technician.
I'm sure someone here will want to be big man on campus and tell you how to do it. Not realizing what happens when a fellow tech in a few months goes on service call and sees that belt isn't showing much use. Now you screwed them because they go searching somewhere else for a print quality issue. A good tech will eventually figure it out but meanwhile you just wasted a lot of their time.
Of course much of this reset info can be found on google search.
Once the items are actually replaced go to service mode, counters select new release then open the big front door, button turns blue then hit start for each..
If you reset the xfer belt without replacing it you will have image problems supreme.
Just for reference the xfer belt is voltage\wear significant.
If you reset the belt without actually replacing it you are asking for poor quality.
I'm only stating this because I've seen "cheaters" screw themselves a dozen times.
Last edited by Synthohol; 02-12-2019 at 10:36 PM.
We know a thing or two because we've seen a thing or two.
Also don't ask me for files without a contributor badge.
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
My thoughts exactly tsb. The life of fuser is rated at 1.2 million and Transfer belt over 1/2 million. Even with that people still want to reset the counters. Good advice from other poster just turn off message (not sure you can do it once message shows).
On the C654 you cannot simply turn off the "replace xxxx" warnings in CE mode.
You CAN set "IU Life Stop Setting" to No Stop.
Perhaps this is possible elsewhere that I am no aware of, but not in CE mode...
Depending on the situation, environment and PQ requirements those transfer belts and fusers will easily go past 1.5x life expectancy with excellent PQ (which requires the reset). Why would you want to do this is self-evident. If the techs use their Machine History booklets responsibly there wouldn't be confusion either (unless they cannot write legibly or someone is illiterate).
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
Bookmarks