Hi all,
I have to replace a broken glass/scanner unit on this old little machine, any tips & time scale to allow!?
Hi all,
I have to replace a broken glass/scanner unit on this old little machine, any tips & time scale to allow!?
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
I have changed many units and it is very simple, I have even exchanged with the bh36. Are you going to change the unit or just the belt?
Let us eat, drink, and be merry, because tomorrow we may die!
For all your firmware & service manual needs please visit us at:
www.copierfirmware.co.uk - www.printerfirmware.co.uk
be careful of pinching wires during reassembly, this is the most common problem i see.
Replacing the whole scanner unit is pretty easy. Just make sure to route the ribbon cables through the appropriate ferrite cores and as mentioned above, be careful of pinched wires. I've done the swap a few times and it shouldn't take much more than an hour or so to remove the old one and put in the replacement.
Bookmarks