Results 1 to 4 of 4
  1. #1
    Senior Tech 250+ Posts
    Join Date
    Mar 2010
    Location
    Lancaster Ohio
    Posts
    258
    Rep Power
    31

    Konica c360 529 finisher. Staple alignment problem

    Have a Konica c360 with a 529 finisher on it at the last page out when stapling doesn't get pulled back in all the way and the staple misses the page. Always seems to happen to the last page. I cleaned all the rollers and it did not seem to make a difference. Don't have very much experience with these internal sorters. Also have another one with 1183 code. Bigger sorter I would just line it up and that would get rid of that code but the smaller one no such luck. Any advice on either of these issues would be appreciated as I have no service manual for very limited experience on finishers thank you

  2. #2
    RTFM!! 5,000+ Posts allan's Avatar
    Join Date
    Apr 2010
    Location
    Centurion
    Posts
    5,387
    Rep Power
    152

    Re: Konica c360 529 finisher. Staple alignment problem

    There is a bulletin out where they show you 2 parts you need to remove to fix the issue. Wish i could point you to that but no access to that anymore.
    My jaw dropped after struggling with that issue for 2 days then got the bulletin from Mr manager that found it somewhere in a moldy corner
    2 minutes later the machine was stapling ok with less parts...
    They actually unclip or pull off(mylars) with some force and no disassembly required. Long time ago.
    Hope someone here got it.

    A0U7 PPB7 00 look at those don't pull them of if you can confirm it first.

    Once all the kinks are taken out of those they are actually half decent.
    Whatever

  3. #3
    Senior Tech 100+ Posts
    Konica c360 529 finisher. Staple alignment problem


    Join Date
    Feb 2018
    Location
    Kankakee, Il
    Posts
    177
    Rep Power
    17

    Re: Konica c360 529 finisher. Staple alignment problem

    The exit rollers and belts will also cause this if they are worn.

  4. #4
    RTFM!! 5,000+ Posts allan's Avatar
    Join Date
    Apr 2010
    Location
    Centurion
    Posts
    5,387
    Rep Power
    152

    Re: Konica c360 529 finisher. Staple alignment problem

    Found the solution?
    Whatever

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here