Hi everyone, before I bite the bullet and order a whole print head for a bizhub C284, anyone experienced a problem where the colours are not aligned, and running all the adjustments in the manual make little or no difference?
Hi everyone, before I bite the bullet and order a whole print head for a bizhub C284, anyone experienced a problem where the colours are not aligned, and running all the adjustments in the manual make little or no difference?
what adjustments have you ran from the manual, normally a initialisation & image stabilisation is enough...are there any codes when you go into tech rep, whats the consumables life etc... on only one m/c have I had to replace the IDC sensors, which was causing that problem, make sure they are clean, if not you'll get "P" codes. if you have "P" codes, you probably won't be able to carry out any gradation/adjustments properly.
Tip for the day; Treat every problem as your dog would.....If you cant eat it or f*ck it....then p*ss on it & walk away...
Photo would be good but if it’s what I think it is then it will be the ph.
Have same problem with C224e out from the box,few years ago,last delivery of C224e before sale end.
Tried everything in SM,replace transfer belt,drums, to test...no joy.
New PH unit solve problem.
98% of the time is dirty idc sensor
Have you done the Print Head Skew Reset?
Bookmarks