Thanks: 
Likes: 
Dislikes: 0_IMG-20190312-WA0001.jpg
Hello guys,
I need help with this I started getting two vertical lines a cross all pages on Yellow and Magenta lines. Drums are at 21%. Shortly after this, error C4631 began to pop up.
Any ideas how to resolve this?
0_IMG-20190312-WA0001.jpg
Hello guys,
I need help with this I started getting two vertical lines a cross all pages on Yellow and Magenta lines. Drums are at 21%. Shortly after this, error C4631 began to pop up.
Any ideas how to resolve this?
looks like a M dev unitOriginally Posted by ttopman
What is distance between this white void areas?
Approx 188mm pitch: Damage on the drum surface
Approx 44mm pitch: Developer conveyance failure of developing sleeve
Yup, I'm thinking drum too. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
I thought I saw LEF Feed. Am I wrong?
Sent from my SM-G960U using Tapatalk
I viewed this print as Ledger (11 x 17) or Full Bleed (12 x 18), SEF. Super B+ (13 x 19) would have larger voids. These are the typical paper sizes used on the presses. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
well I can't remember the last time I didn't agree/digress to your views BC.. so put another one in the "W" column
near the bottom of the voids there seems to be a mark that may be foreign material stuck somewhere that pushes the mag roller back momentarily?
We know a thing or two because we've seen a thing or two.
Also don't ask me for files without a contributor badge.
Measured the lines, it's approx 88mm gap.
I have this on Yellow too. Dev mag roller shows no sign of failure.
Find this very annoying
We've had the drums checked. There was some artifact there, had it removed at the expense of the drums. The problem though is that I have this on Yellow as well, the yellow drums are clean and good.
Reply With Quote
Bookmarks