Hi all
I got a C654 the has a image shift issue when printing on thick stock (300gsm so in spec).
Fuser is fine, changed main drive unit (even though no P codes),transfer roller,belt is still new.Adjusted fuser speed up and down but same result.
At first i thought it was the paper but got paper from another customer who also has a C654 and no issues.
Next thing i am going to try is the transport/conveyance unit in the door.
Am i missing something??
Did you try bypass separation roller adjustment, there are two positions.
A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
Blessed are they who can laugh at themselves, for they shall never cease to be amused.
I don't reply to private messages from end users.
So the color registration is fine?
Is the shift consistent?
Whatever
Re: C654 image shift
AS ANY GOOD TECH WOULD SAY
do you have a print sample???
hehehe
Clean those rollers and clean them good. Which tray are you feeding from?? The registration roller could be suspect in this case. ive seen bent out of shape entry points could be binding on one side, check those springs which holds the rollers down. one might be worn or came off. i had a few like that. they just pop right off from the shaft.
good luck
IIRC there are specific image registration adjustments based on paper source and media type. In other words you can adjust image registration differently for 300 gsm media or bypass tray, or some combination. =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=
Update
The conveyance/registration unit sorted issue out.
Thanks: 
Likes: 
Dislikes: 
Reply With Quote
Bookmarks