Page Pro 1490 copy black border

[Dumus]

The boys ,
I have a problem with PP 1490.
I am RICOH boy, but this model 1490 is the same as ricoh SP 1100 (1180), and many others (XEROX, Sagem .....).
The whole problem was created after cleaning the glass (original glass)!
Everything is OK in the print mode (print).
In copy mode on glass, I have a black line on the right side (copy 1), everything adjusting in normal (N) and set to A4.
When adjusting the "flatbed margin" - (854) to the maximum,
the line is reduced but not enough, and the diodes on the scanner are all bright.

Have any idea, what to do?

Print mode :
SP 1100 PRINT.PDF
Copy 1 :
SP 1100 copy 1.PDF
Copy 2 :
SP 1100 copy 2.PDF

[allan]

Its been ages since i last seen these machine.Sagem i believe.
So only the general things i can think of. It the white correction patch intact and clean?
Cant remember does this use a CIS or CCD?

Seen better looking potato stamp prints then those samples.

[Toxic]

Seen better looking potato stamp prints then those samples.

Lol,you are very right

Its a CIS if i remember good.

@Dumus
Does black strip occur when copy from adf or just flatbed?
Did you try scan,is it same?

[blackcat4866]

If that line is crossfeed, maybe you've got a break in the lamp cable? Maybe the lamp is shutting off? =^..^=

[Dumus]

Does black strip occur when copy from adf or just flatbed?
Did you try scan,is it same?[/QUOTE]

Yes, black strip is in when from ADF, and in scan.

blackcat4866 :

All the time, the lamp lights up the whole length, and it normally goes out. Do not blink.

??????

[allan]

If that line is crossfeed, maybe you've got a break in the lamp cable? Maybe the lamp is shutting off? =^..^=

Its a crap little A4 SEF machine.

[blackcat4866]

Its a crap little A4 SEF machine.

Ah, thanks.

hmmm ... so maybe you've got something blocking the primary charge, like a broken cleaner? =^..^=

[allan]

Ah, thanks.

hmmm ... so maybe you've got something blocking the primary charge, like a broken cleaner? =^..^=

hey not playing that. hehe