c6500 c0213 code

[totoro]

Has anyone had any experience with a c-0213 code on the c6500? It seems to pop the code when feeding heavier glossy stock from trays 4 & 5. The paper stops before it gets into the fuser. Since other stock seems to feed fine I have ordered new feed and pick-up rollers. Does anyone have anymore advice for me ? TIA

Totoro

[konicaguy1970]

replace the one way drive gear for exit pressure konica part#A03U909502).

[totoro]

Thanks for the reply. I just tried to find the part in my manual and couldn't find it. Could you tell me where it is in the parts book or machine? Sorry but I don't have much experience with these. Thanx Totoro

[konicaguy1970]

	Quote:			Originally Posted by totoro
	Thanks for the reply. I just tried to find the part in my manual and couldn't find it. Could you tell me where it is in the parts book or machine? Sorry but I don't have much experience with these. Thanx Totoro

just order the part number i gave you and replace it.

[redime]

	Quote:			Originally Posted by konicaguy1970
	replace the one way drive gear for exit pressure konica part#A03U909502).

Listen to the man, hes right on the money

Description

C-0213 intermittantly.

Solution

CAUSE: One-way drive gear for exit pressure is slipping.

SOLUTION: Replace one-way drive gear (p/n A03U909502).

[totoro]

Hi Guys,

I have ordered the parts you suggested. I didn't mean to sound as if I doubted you as to what to change, I just literally didn't know where these parts where to change them. I only have 1 of these machines in my territory so I have next to no experience with them. I'll try to find them in the parts manual. Thanx for eveything !!

Totoro

[konicaguy1970]

its on the fuser. no problem

[ni311]

Try with spaces between "A03U 9095 02" or after its name "PAPER EXIT GEAR /5 40T"

[totoro]

Hi Guys,

Thanx for all who helped me on this.I changed the gear and the 0213 code went away. The gear is on the exit ass. and what a bear it is to take the finisher and RU unit off to get to. Now I am getting what looks to be an intermittent stall. The paper looks like it has been stalled in the fuser. On a 12x18 sheet it is buckled about 8inches down and again about 12-12 inches down. Would this be one of the 1 way gears on the frontside of the fuser? Has anyone seen anything like this? TIA