Bizhub 600 Jobs Holding

[joneze]

Customer has a 600 that when printing to or copying from it will just hold the job in the job list say its printing them but does nothing. The machine will work if unplugged for a while but will hold jobs again shortly after.

Tech support say they have had one instance which turned out to be a problem with the sub hopper not getting toner. This has been checked and seems to be fine.

Has anyone else had similar fault or any ideas what this could be.


Cheers
Mark

[pepper38_cnd]

This issue was solved via firmware October of last year, this lockup issue was more prevalent on machines equipped with fax boards. This can also happen if your HDD is flakey, we drill holes in the back covers to help prevent HDD from over heating.

[RockETop]

I do not see an October release. Do you have the version?

[xphyperleon]

check for cap of the toner if it is fitted with coupler that drive the toner bottle inside.if that the case toner supply is not consistent.

[kmcopier]

This was a kown bug........ place one original in de ADF set the finishing option on staple. you will see that there will be two jobs with the same name and one jobs stays in the display all other jobs are coming behind this and at last the Bizhub 600 hangs up

[pepper38_cnd]

Here is the firmware that solved the issue for us

https://download.yousendit.com/Y2o5QndBUzhsUjljR0E9PQ

[copier skills]

I had that problem. I had currupt firmware. Had to reflash the firmware. Machine kept locking up. Also in another instance different copier i had fax portion causing a problem.

[joneze]

Thanks for all the suggestions. Firmware is not the issue this was one of the first things we did to solve it. We have also dissconnected the hard disk and it still locks out.

We are running out of ideas for this one.


Cheers

[alexxcopier]

in the job list say its printing them but does nothing

hi there, i had a similar problem and was solved with Replacing the toner control sensor board • Toner control sensor board: Every 2,500,000 prints
i replaced board on 1,800,000 prints
before do this I upgraded firmware version and phase , but without result

check out

[tech51]

I agree with Alex, the toner control sensor is responsible for all sorts of locking up/not warming up/not printing problems. I would go through the drum peculiarity adjustments, if it doesn`t set up correctly, change the board (sensor board in drum carriage)
PS I am assuming your drum and dev are in good condition.