Any body knows what can we do otherwise than xhange developer
Made 124k copy - recource 150k...
Any body knows what can we do otherwise than xhange developer
Made 124k copy - recource 150k...
Can`t change developer (error c-2453)
Developing motor test is OK
TCR sensor test is OK (OUT:NOW)
try to test PRCB
Any body can save us?
When do all reset (switch ON with pressed yellow RESET key) c5501 try to start,
- show initialize HDD
- show adjusting
and immediately show call service (c-2453)
try to change tcr sensors with another developing unit, be carefull not to spill the developer.
try to add some toner to the developing unit
(or try to remove toner from developing unit...how? I don't really now, sorry only theory for that)
When the developing motor/Cover the specified value.
(M22) is ON, the maximum
detection value of TCR sensor/C
(TCRS/C) is the specified value
and the difference between the
maximum detection value and
the minimum detection value is
this range can be changed if the developer is low or high (TCR ratio). this can be change with:
replace developer,
add toner
remove toner
because we don't now which are these values.
Did you check the Cyan TD Sensor connector and the harness to the back of the maschine? Maybe something is broken or short circuit
If sometimes you feel a little useless, offended and depressed always remember that you were once the fastest and most victorious sperm of hundreds of millions!
Step1.
Manually add some toner to the Dev unit.... then turn the Dev motor on in I/O mode to stir the toner in
Step2.
Go to .....Service > Process adjustment > Sensor output check > Toner Density Return Mode.... and run all ON
the offending colour output value will likely be over 215 it will slowly reduce to the normal of 128.
An ouput value of over 220 will give you a hard on fault of 24-5x, adding the toner manually just gives you a foothold value to get the toner return working.
To avoid it happening again.
Make sure that the Image Quality Stability is set to Stability and not speed.
Also make sure that the toner bottle has been changed and that customer is not opening and clsing the toner door to clear the msg.
I have tried this "Go to .....Service > Process adjustment > Sensor output check > Toner Density Return Mode.... and run all ON" yesterday and save me.
My question is, if there is a lot of toner inside, this step can remove toner from dev. unit or is only adding toner?
thanks
You can only add toner by this
the output value nominal is 128
Over Toned <128
undertoned >128
to remove toner run sky shot solid of the colour you want to remove........ but you would only want to add toner to fix a C-245x problem.
C-245x is caused by machine depleting dev unit of toner to quickly and output value goes too high (220+) then unit is undertoned.
Bookmarks