Bizhub 163 total count reset

[freixi]

Hello the team,

1.is es possible reset the total counter from bizhub 163?

2.Y have the programmer from programing the DS2432
but with which software can I use it to program?
is es possible wih the poniprog?

Sorry my english, i from Germany.

Thx for all.

Freixi

German.
Hallo das Team, ist es moeglich den bixhub 163 den gesammtcounter zurueckzustellen?

desweiterem suche ich die software um den DS 2432 chip zu programmieren. Den passenden programmer habe ich bereits.
Gehts mit Poniprog?

Danke im voraus

Freixi

[pepper38_cnd]

I,m not sure what programming the the DS2432 has to do with the Bizbub 163. But the answer to your question is, no you cannot use PonyProg to program the DS2432 you must use a 1-Wire type program and programmer.

[freixi]

Thank you for your reply.
The bizhub 136 is the only problem that I count on 000000000 wishes.
I have the 1-wire program but a demo version and I can not write.Kann someone the 1-wire program receive? would be very grateful.
Many thanks in advance

freixi

[ni311]

To reset the counter of your Bizhub 163, you need a new NVRAM. Do a search, I saw a few people selling these things.

[freixi]

Thx for reply

NVRAM ? Wahts tis??lol... is es a new hardware, or the chip?

when there is a new chip is what is inside the original?
Can the man re-program?

Thank you

freixi

[kesserling]

The nvram is on the back of your copyer
after take it and send me these nvram and before print the counter

[freixi]

Hello.
Thanks for the reply .. will send bad, I'm in Germany and portugal and do not know where the NVRAM is. is in the soket?

I still search the 1-Wire Software for a DS2432 to writen, I have a serial programmer.

Thank you very much

Freixi

[manuals4you]

For what legitimate reason would you want to reset the total page count?
In civilized countries doing this is the same as resetting a car's odometer, highly unethetical and illegal.

Paul@justmanuals.com

[freixi]

Hello
ilegal is the resetting of the tonner chips.
The copier consists entirely of new parts, the electronics is another copiers have been installed. that is why I wanted the set to zero


sorry if it has been misunderstood

Thank you

Freixi

[manuals4you]

Oh, so the parts you installed came from a copier with a zero count?