Data light flashes, you can ping it but does not print. I have done a nic & nvram recovery, and it is on v3.05 firmware. Customer is chargable and very nice so i do not want to throw boards at it if i can help it.
All help appreciated.
Data light flashes, you can ping it but does not print. I have done a nic & nvram recovery, and it is on v3.05 firmware. Customer is chargable and very nice so i do not want to throw boards at it if i can help it.
All help appreciated.
Did u actually reflash the machine firmware?
Regards!
A.
DESCRIPTION: Unable to print. The data light blinks but no document prints (including a test page). SOLUTION ID: 238248
SOLUTION: CAUSE: Incorrect Image Controller setting.
SOLUTION: Set the proper Image Controller setting. To set the Image Controller mode, perform
the following:
1. Enter Service mode.
2. Select System 2.
3. Select Image Controller setting.
4. Select Controller 0.
5. Select End/Exit to exit the service mode.
K, no codes in machine (account tracking or anything?)
A.
Heh Beaten! What mrwho said!
Does it show in the log/job history?
Regards!
A.
Wait a couple of minutes... it's probably reinitializing...
Thanks. Tell her I'd like to, but I'm a little bit far away - although if I ever go to the UK (about 1000miles), I'll call you to charge that drink!
Glad it worked. Cheers!
Bookmarks