service / tech rep mode not accessible

[clubsys1]

recently replaced the drum and developer and cannot access service mode for bizhub 350. The machine instantly defaults to code c2557 and will not on re-boot open to service mode.

any suggestions?

[deep]

You should carry out F8 right away after machine being turn on.

[AZ Copier]

Have you tied getting to service mode through trouble reset?

[clubsys1]

i have tried holding utility button down and power on and still no reset option...just error code.

How can i or why can't i get directly to F8 before error?

[Juggy]

hi do warm boot when you get the konica minolta logo with a dot in centre left side press 3 then enter "00000000" enter reset mode. when you are in this mode enter stop,0,0,stop,0,1. then you can run F8 then rest the counters for drum & Developer counter. good luck.

[clubsys1]

I tried to do this earlier...when i boot the machine and get to the konica logo and press 3, nothing happens. i just end up at the same error code.

what am i missing?

[3angle]

To get the "trouble reset" on BH250/350, You have to press the
"warm restart switch" which is under the CompactFlash cover (about 10cm to the left from the LAN-female RJ-45) and than when a black point appears at the center on the left-hand side of the screen, enter “3” from the Key Pad,
and enter the 8-digit service code and touch "END"

[Kmdurrin]

You may want to try a new drum and developer.

Per SSD bulletin #TAUS0655275EN
SOLUTION: Replace both the drum unit and developer at the same time. Once the code occurs, developer must be replaced to properly recover.
The correct procedure for replacing the drum is as follows:
1. Select Tech. Rep. Mode => Counter => Special Parts Counter => PC Life.
2. Press the Clear Key to clear the counter value.
3. Turn OFF the main power switch.
4. Open the Right Door.
5. Remove the IU.
6. Remove four screws (silver) and disassemble the Photo Conductor Unit and the Developing Unit.
7. Replace the Photo Conductor Unit.
8. Remove three screws and the Developer Scattering Prevention Plate.
9. Remove the Toner Supply Port.
10. Remove the Developer.
11. Set the developer while rotating the gear in the direction of the arrow.
12. Reinstall the Toner Supply Port.
13. Using three screws, secure the Developer Scattering Prevention Plate.
14. Install the four screws to secure the Photo Conductor Unit and Developing Unit.
15. Install the IU in the copier.
16. Turn ON the main power switch.
17. Select Tech. Rep. Mode => Function => F8 and press the Start Key.
Notes :
a. After replacing the developer, be sure to execute F8 under Function of Tech. Rep. Mode.
b. When the main power switch is turned ON, execute F8 quickly.

[clubsys1]

tried the reset...didn't work.

Why can i not access tech rep mode from the menu? better yet, how do i simply get to tech rep mode to reset the counters because i'm not doing this right.

thanks

[pepper38_cnd]

Turn the machine on with the right side door open, enter tech rep mode and go to F8, close door when the start indicator changes color press to start the F8.