Originally Posted by
BVulgaris
Is there a way to adjust the bypass tray guides? (not the guides attached to the ADU that pulls out). When looking at the top and bottom guides where the paper goes vs. the guides that pull it into the main paper path and reg rollers they dont quite line up and there is room for the paper to crash into the upper secondary guide. New rollers are on, checked that the plate mentioned in earlier posts were not bent. But if 256gsm stock were to buckle on the top part of the second set of guides i could see where the rollers would skip on the paper and throw a J-1709. It also seems that the frame/rails must be at an angle because the bottom guides where the paper from the trays feed into the main engine scrape along the bottom of the frame when the ADU drawer is pulled out or put back in.... you can hear the scraping metal.
Bookmarks