BIZHUB 501

[Himmelsbote]

Hi,

sorry for my bad english :-)


Zitat:"Careful!! If you had the toner supply unit out for any reason and the toner solenoid off when you reassemble it, you can use the wrong screw(s) (longer ones) into the solenoid and short it to the frame and kill your control board (or icp 4 I suppose (never checked!))... its like that for the 420 series and would bet its similar for the 421 series as well! Just a though!
A!"

i have the same Problem many times and i dont know what i do wrong.
everytime after the C2403 and change the sensor.
if i change the Oacb is not working. Same error.

can you tell me which Screw is to long or to small or send me a picture maybe?

Many many Thanks .
Himmelsbote from Germany

[Downunder]

Usually jams in the registration relate to the two clutches in the ADU section. Probably clogged up with grease.

[mjunkaged]

Armaddon, Sounds like icp 4 on the prcb is blown. Here's a list of icps and fuses. Imageshack - 360420500icplist - Uploaded by huronman

I tried that link last week and it says it's gone...do you still have the image? I could sure use it now and for further troubleshooting....they're hard to find just poking around with a magnifying glass!

[Synthohol]

6 year resurrection! nice!

[Phil B.]

I tried that link last week and it says it's gone...do you still have the image? I could sure use it now and for further troubleshooting....they're hard to find just poking around with a magnifying glass!

A link 6 years old doesn't werk? Imagine that!!!!
DEAD FUCKING THREAD!!!
START your own new thread ..stating everything you have tried and/or replaced.

WE consider anything over 2 years from last comment a DEAD THREAD!!



Sent from my SM-G960U using Tapatalk