Question about changing developer on Bizhub 163

[MihaiGSM]

Hy guys! Today i changed the developer and drum on bizhub 163 because it showed on display "MaintenaceCall2". Everything fine, but after changing these, i did ATDC autoadjust with toner bottle inside, by mistake. The value of ATDC after the process finished was 143, i turned off and then on the copier, but the message "Maintenace call2" didn't disapear. To clear the message on the screen a did a reset on service menu.
The copier work fine, the image on the paper is very good, but the question is: it will work again fine next 60.000 copies/prints? Thanks in advance!

[harry2007]

of course!...why not?the value 143 it's OK. it's no other reason for your concern.

[perdana]

You need to clear the Drum counter.