-
Senior Tech
100+ Posts
- Rep Power
- 0
First of all update the firmware on the machine, when you fit a new board always update the firmware.
Does the flaring happen only on prints or does it happen when copying also?
If it is a print issue then try different drivers (PS and PCL)
If copying is affected then you will need to look at the leds and imaging units
Good Luck
-
Senior Tech
100+ Posts
- Rep Power
- 4
I cleaned the led assys and the problem is gone. I appreicate your help. sorry it took so long. just fixed it yesterday. i wish there was a way that we could all report back to this board on our progress when we ask a question and if it fixes our problem we need to report back.. thanks
brent
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules
Bookmarks