Thanks:
0
Likes:
0
Dislikes:
0
-
Technician
- Rep Power
- 30
how 2 remover toner units
Hi dear frnd,
pls tell me easy way 2 remove toner hopper units. (c 500 pro) i wanna clean toner level detect sensor,
BR
-
Technician
- Rep Power
- 30
Sir,
First check your transfer belt, is it being cleaned no streaks?(If streaks replace cleaning blade or vaccum out the assy. Second clean the three sensors inside the machine that monitors the transfer belt will be on the left side of the belt inside the machine all three have covers watch out for two of them they have springs they came be cleaned by reaching into the machine from the right side with drum/transfer belt section open, DO NOT LEAN ON THE DRUM DRIVE SHAFTS!!!! Also check that all four charge corna housings are snug in position. May also require you to remove reg assy. Assy is where the sensors are located two screws and a connector (Have to get way in the back of the machine, from the front no back cover)Mag screw driver once removed clean toner dust, and clean under the actual sensor covers themselves. Of course the sensor assy could be bad. There are three small circuit boards on the assy. Hope this help
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks