We are looking at the option of refurbishing our C250 Image units with Rebuild kits. (Drum, Blade & Reset Chip). So we have tried a couple and our success rate has been ZERO...... The quality is terrible.
Has anyone done these before with any success???
Maybe its our drums & blades???
The state of the developer in the image units.??
Or are we just not doing it Right????
any help would be greatly appreciated.
We are looking at the option of refurbishing our C250 Image units with Rebuild kits. (Drum, Blade & Reset Chip). So we have tried a couple and our success rate has been ZERO...... The quality is terrible.
Has anyone done these before with any success???
Maybe its our drums & blades???
The state of the developer in the image units.??
Or are we just not doing it Right????
any help would be greatly appreciated.
We looked at this in Calgary.
In short...not worth the time and energy, at least from a tech point of view.
__________________________ "Many years ago I chased a woman for almost two years, only to discover that her tastes were exactly like mine: we both were crazy about girls."
---Groucho Marx
Are you having any error codes when you re-chip the IU, or are you just getting poor copy quality? When we re-chip we get TCR codes because of the depleted developer in the IU. The customer keeps having to open and close the front door to get the code to go away.
Once I got a code when rechipping, but it was for the yellow IU and I had re-chipped the magenta IU . For the rest didn't get codes, just poor image quality, toner/developer spills, color lines and so on... But make sure you re-chip before the "change unit" message appears... and after you re-chip don't perform calibration - cause the colors will go crazy.
. For the rest didn't get codes, just poor image quality, toner/developer spills, color lines and so on... But make sure you re-chip before the "change unit" message appears... and after you re-chip don't perform calibration - cause the colors will go crazy.
Linear Mode
