| Quote: | | | | | | | |
| thanks . 
and the last question , do I need some special tools to get to those fuses , or regular screwdrivers are ok ? | |
| | |
No, just remove the unit, a screw driver to remove the cover, a knife to take the shrink tube off, wrap the old fuse in parallel with the new, tape it up and close everything. Back into the machine and yer done. To remove the old fuser, two covers, one on the document tray just beneath the exit side of the fuser...single screw to remove that cover to allow you access to data cable connector. Single cover inside front door right hand side covers AC power to the fuser.
Linear Mode
