konica 7033 no lcd display

[barratec]

Hi, just forwarding that incoming mail perhaps?

Hans

Hi hanson! I've just send to you by mail the utility that you need.

[Hansoon]

Hi hanson! I've just send to you by mail the utility that you need.

Hello Barratec,

thanks for your efforts, very kind. It didn't came yet so herewith once again the e-mail address:

nospam@rex-technika.com

Hansoon

[barratec]

Hello Barratec,

thanks for your efforts, very kind. It didn't came yet so herewith once again the e-mail address:

nospam@rex-technika.com

Hansoon

Hello, i've tried again to send to you the utility, i'll be more lucky???

[Hansoon]

Hello, i've tried again to send to you the utility, i'll be more lucky???

No unfortunately not. Would you kindly try alternative:

hans@rex-technika.com ?

Many thanks

Hansoon

[mdm7266]

Hi, just forwarding that incoming mail perhaps?

Hans

send me your email

[mdm7266]

Would anybody kindly share this utility with me?

nospam@rex-technica.com

Thanks

Hans

i look at the ISWtrns utilty on my email and found out that the download is no longer available. maybe you could ask for member barratec for the firmware to activate the download again. it may require his permission on his mail

thanks

[barratec]

i look at the ISWtrns utilty on my email and found out that the download is no longer available. maybe you could ask for member barratec for the firmware to activate the download again. it may require his permission on his mail

thanks

Hi mdm7266,
if you give me your email address i'll send you the link to download ISWtrns utilty. My mail is : barratec@tiscali.it

Bye.

[fvincent]

Kind Sir. Could I have a copy of the ISWtrns utility as described. I will be greatly in your debt!

Thanks,
Floyd

floydvincent@verizon.net

I attached the system (v.45) and image (v.26) firmware to write via parallel cable and ISWtrns utility.
If you need this utility too send me a email address.

[letragraphics]

I attached the system (v.45) and image (v.26) firmware to write via parallel cable and ISWtrns utility.
If you need this utility too send me a email address.

HI! May You please send me the ISW transfer utility software for konica 7040 at letragraphics@yahoo.com

[mdm7266]

hello there again. i have a new problem with my main control board. when i turn the power switch on, (left rear side) i hear clicking sound as if a relay on power supply2 is turn on, but no machine reaction and no lcd display. this time no led is on on panel. i replaced the control board with spare and it work fine. Now my question is can i repair the control board? i suspect that a fuse is blown on control board (no display board) or do i need to flash the board?

i have also another control board that when i replaced with it, a code F80-4 is indicated on lcd screen also even i replaced the parameter board on top of it. What can i do to correct this error? thanks