Thanks:
0
Likes:
0
Dislikes:
0
-
konica minolta c252 code c5102
so the book says make sure the connector is connected on the main motor. then replace in order pwb m then pu 1. well in real life I don't have these parts in stock. so has anyone had this problem and does the pwb m usually take care of the problem? fuses? I did not have time to take the machine apart today. I am doing research on this.
any ideas?
thanks very much.. brent
-
Senior Tech
100+ Posts
- Rep Power
- 36
Main Motor drives Imaging Units, Transfer Belt, etc. Check to see if Main Motor drive is binding before start to replace boards and such.
-
I see that minolta has a bulletin on this. seems like the motor that drives those units goes out. I should have spent more time today on it. there was a jam in the machine. it is just probably just still jammed... I am going back in a couple days to check it out again.
thanks
brent
-
Every time i have had this code ( about 5 times ) it has always been the motor.................
-
PSP
100+ Posts
- Rep Power
- 33
jou check it by swapping it with the motor fro the color one make a color copy and you have a error on the color motor it's known problem
-
sounds good to me. I got to read up in the service manual. are these motors hard to swap out?
thanks
brent
-
PSP
100+ Posts
- Rep Power
- 33
no only you have tp remove the unit with the mfp board's ,hdd in it. it's good discripted in the manual if you have any change take a motor with you saves a lot time
-
I found it on page 143 in the manual. I am going to order a motor to take with me.. hopefully that is it rather than going into the pwb m or pu1. ya know?
thanks for your imput
brent
-
c5102
can you post the service bulletin from konica on this?
-
AccService
100+ Posts
- Rep Power
- 0
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks